What to Do with RO Reject Water: Uses, Limits and How to Reduce It
RO reject water is not waste. Learn what is in it, where it can be reused safely, where it must not be, and how to cut the amount your plant sends to drain.
G1 Aqua engineering team
3 min read
Every RO plant sends some water to drain. In a home unit, that can be two or three litres for each litre of drinking water. In a well-designed commercial plant it is closer to a third of the feed. Either way, it is worth knowing what is in it and what to do with it.
What reject water is
Reject water, also called concentrate, is the feed water that did not pass through the membrane, carrying the salts that were left behind. Its TDS is higher than the feed. A quick rule: divide the feed TDS by the share that becomes reject.
Example: at 60% recovery, 40% of the feed is rejected, so the reject is about 2.5 times as salty as the feed (1 divided by 0.4). Feed at 800 mg/L TDS gives reject near 2,000 mg/L.
It is not dirty in the usual sense. It has no added chemicals except the anti-scalant dose. But it is too salty to drink.
Where it can be reused
- Flushing toilets, where the building has a separate flushing line
- Mopping and washing floors, vehicles and yards
- Construction work, for curing and mixing where the salt level is acceptable
- Cooling tower make-up, if the tower's chemical programme allows for the salt
- Gardening, mixed with fresh water and only for salt-tolerant plants
Where it must not go
- Drinking, cooking or food preparation
- Boilers, unless treated again
- Plants and crops that are sensitive to salt
- Open drains that flow into a village pond or borewell area. Check local rules for discharge
How to send less of it to drain
- Raise the recovery, carefully. A higher recovery sends less to drain but concentrates the salts more, so scale risk rises. It works only with correct anti-scalant dosing or a softener.
- Add a second stage. Reject from the first stage feeds a smaller second plant, lifting total recovery.
- Fix leaks and wrong settings. Many plants reject more than they should because the reject valve was opened wide at installation and never adjusted.
- Use an RO only where it is needed. Softened water, not RO water, is enough for laundry and hot water.
Storing and handling reject
Keep it in a covered tank. Standing reject water can grow algae and attract mosquitoes. Label the pipes so nobody connects the drinking line to it by mistake.
Reusing a building's wastewater in general, including greywater, is covered in greywater recycling and reuse. Plants are designed around reject and recovery from the start, so mention your reuse plans when you ask for a commercial RO plant.
Know someone with the same problem? Send them this guide.
Products in this guide
Is this your problem?
Send a photo or your water report. An engineer will tell you what fits.
Ask on WhatsApp
